Question: How Can I Hide My Well Head?

How do I find my well head?

Look for locations where a well would be likely to be placed: continue by looking in the building for a sketch of well location – often left in a basement or crawl area over or close to the pressure tank and pump/controls, or sometimes even sketched on a ceiling joist or wall where the well pipe exits the building..

How much does it cost to cap a well?

How to seal a well? Wells need to be sealed by a licensed well contractor. This service can cost between $500 to $1,500 or more for sealing an average four-inch diameter domestic well.

How do you maintain a well?

Keep hazardous chemicals, such as paint, fertilizer, pesticides and motor oil away from your well. Periodically check the well cover or well cap on top of the casing (well) to ensure it is in good repair. Always maintain proper separation between your well and buildings, waste systems, or chemical storage facilities.

How do I find an artesian well on my property?

Sometimes a buried well can be found with a metal detector. Sometimes you can find that information on file with property records. Failing those things, the only way to determine the well location is to follow electrical lines and pipes from the house to the well. And that means digging.

What can you plant around a well?

Planting Options Leave a buffer of at least 1 foot around the well cover to allow access. Ornamental grasses work well for quick cover around the well. Many ornamental grasses grow several feet tall, so they will hide the cover completely. Another option is to plant a flower garden around the cover.

How do you decorate a water well?

5 Ways to Decorate Your WellFlowerbeds. Surround your well cap with a seasonal flower bed. … Rock Gardens. Surround the well cap with large rocks, burying each about one-third in the ground so that it looks natural. … Pump Houses. … Above-Ground Pipes. … Wishing Wells.

How Far Should a well be from a house?

The state’s horizontal separation distance (setback) mandates a minimum of 100 feet. However, if you have a well that serves a single family dwelling and due to lot restrictions, you cannot achieve 100 feet, the setback may be reduced to a minimum of 50 feet.

How far should a septic be from a well?

50 feetDepartment of Health in many States requires that new septic tanks or human-waste lagoons to be installed at least 50 feet from a well. Septic tank drain fields must be at least 100 feet from a well.

Is it OK to cover a well head?

DO NOT use any well coverings. Even though the sight of your wellhead may not be your favorite thing, you should not cover it up with any fake rocks, gravel, treated wood, or wishing wells.

How long do wells last?

30-50 yearsThe average lifespan of a well is 30-50 years, although they can last longer or shorter depending on different circumstances. If the well you are buying is over 20 years old, you should at least factor in replacing the parts that commonly fail into your home buying budget.

Can I fill my well with water?

Adding water to your well is not recommended. It could contaminate your supply, and will not alleviate your water shortage problems during drought conditions.

Does a well pump need to be covered?

Make sure the well is securely covered and the pump is inside an insulated enclosure. The water inside the well cannot freeze since it is always below the frost line. … Keep these parts covered in insulation and the pump should be inside an insulated housing.

Can I dig a well anywhere?

You probably can drill your own well on your property. You, of course, would have to contact your local building department to see if there are any regulations that must be followed. Some states and cities may still charge you for the water that’s pulled from your land, but that’s a debate for another day.

What does a well cap do?

A properly installed well cap separates potential pollutants from your drinking water. … The cap, which should be sealed tightly at all times, keeps out everything from liquid contaminants to bugs that can crawl inside a well and wreak havoc.

How do you hide a wellhead?

Here are a few ideas: Place a Fake Rock Cover over top your pipe, it is easy and affordable. Placed over the top of the pipe your eye goes to the sculptures and not the pipe. It hides the wellhead inside and can be removed for easy to access the if needed.

How do you hide a well?

Here are some creative ideas on how to hide a well cover in your yard.Plant Around The Well Cover.Add Garden Structures.Apply Positioning Techniques.Use a Potted Plant.Lay a decorative stone.Outdoor building.Put a fence around it.Don’t plant trees beside the cover.More items…•

How does a well work?

What Is A Well? Basically, a well is a hole drilled into the ground to access water contained in an aquifer. A pipe and a pump are used to pull water out of the ground, and a screen filters out unwanted particles that could clog the pipe.

Does well water run out?

Whenever it is warm out, there is a chance of your private well running dry. Most wells flow without problem through warmer months, but in areas of drought and a low level of groundwater there is a chance for them to run dry. Read on to learn about the signs of a dry well and what can be done to fix one.

What are the 3 types of wells?

There are three types of private drinking water wells.Dug/Bored wells are holes in the ground dug by shovel or backhoe. … Driven wells are constructed by driving pipe into the ground. … Drilled wells are constructed by percussion or rotary-drilling machines.

How do I know if my well water is safe to drink?

The only way to tell if your drinking water is safe is by having it tested at a certified laboratory. Harmful bacteria, parasites, and viruses are invisible to the naked eye, so water which looks and tastes good may not necessarily be safe to drink.